dt-bindings: Remove PicoXcell bindings
[linux-2.6-microblaze.git] / Documentation / devicetree / bindings / net / macb.txt
1 * Cadence MACB/GEM Ethernet controller
2
3 Required properties:
4 - compatible: Should be "cdns,[<chip>-]{macb|gem}"
5   Use "cdns,at91rm9200-emac" Atmel at91rm9200 SoC.
6   Use "cdns,at91sam9260-macb" for Atmel at91sam9 SoCs.
7   Use "cdns,sam9x60-macb" for Microchip sam9x60 SoC.
8   Use "cdns,np4-macb" for NP4 SoC devices.
9   Use "cdns,at32ap7000-macb" for other 10/100 usage or use the generic form: "cdns,macb".
10   Use "atmel,sama5d2-gem" for the GEM IP (10/100) available on Atmel sama5d2 SoCs.
11   Use "atmel,sama5d3-macb" for the 10/100Mbit IP available on Atmel sama5d3 SoCs.
12   Use "atmel,sama5d3-gem" for the Gigabit IP available on Atmel sama5d3 SoCs.
13   Use "atmel,sama5d4-gem" for the GEM IP (10/100) available on Atmel sama5d4 SoCs.
14   Use "cdns,zynq-gem" Xilinx Zynq-7xxx SoC.
15   Use "cdns,zynqmp-gem" for Zynq Ultrascale+ MPSoC.
16   Use "sifive,fu540-c000-gem" for SiFive FU540-C000 SoC.
17   Or the generic form: "cdns,emac".
18 - reg: Address and length of the register set for the device
19         For "sifive,fu540-c000-gem", second range is required to specify the
20         address and length of the registers for GEMGXL Management block.
21 - interrupts: Should contain macb interrupt
22 - phy-mode: See ethernet.txt file in the same directory.
23 - clock-names: Tuple listing input clock names.
24         Required elements: 'pclk', 'hclk'
25         Optional elements: 'tx_clk'
26         Optional elements: 'rx_clk' applies to cdns,zynqmp-gem
27         Optional elements: 'tsu_clk'
28 - clocks: Phandles to input clocks.
29
30 The MAC address will be determined using the optional properties
31 defined in ethernet.txt.
32
33 Optional properties for PHY child node:
34 - reset-gpios : Should specify the gpio for phy reset
35 - magic-packet : If present, indicates that the hardware supports waking
36   up via magic packet.
37 - phy-handle : see ethernet.txt file in the same directory
38
39 Examples:
40
41         macb0: ethernet@fffc4000 {
42                 compatible = "cdns,at32ap7000-macb";
43                 reg = <0xfffc4000 0x4000>;
44                 interrupts = <21>;
45                 phy-mode = "rmii";
46                 local-mac-address = [3a 0e 03 04 05 06];
47                 clock-names = "pclk", "hclk", "tx_clk";
48                 clocks = <&clkc 30>, <&clkc 30>, <&clkc 13>;
49                 ethernet-phy@1 {
50                         reg = <0x1>;
51                         reset-gpios = <&pioE 6 1>;
52                 };
53         };