ARM: dts: logicpd-som-lv: Move pinmuxing to peripheral nodes

Move some pinmux references to their respective peripherals.
This keeps the pins in safe-mode until they are requested.

Signed-off-by: Adam Ford <aford173@gmail.com>
Message-Id: <20220303171818.11060-2-aford173@gmail.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

diff --git a/arch/arm/boot/dts/logicpd-som-lv.dtsi b/arch/arm/boot/dts/logicpd-som-lv.dtsi
index b56524c..5475e5d 100644 (file)
--- a/arch/arm/boot/dts/logicpd-som-lv.dtsi
+++ b/arch/arm/boot/dts/logicpd-som-lv.dtsi
@@ -27,6 +27,8 @@
 
        /* HS USB Host PHY on PORT 1 */
        hsusb2_phy: hsusb2_phy {
+               pinctrl-names = "default";
+               pinctrl-0 = <&hsusb2_reset_pin>;
                compatible = "usb-nop-xceiv";
                reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; /* gpio_4 */
                #phy-cells = <0>;
@@ -144,6 +146,8 @@
 };
 
 &usbhshost {
+       pinctrl-names = "default";
+       pinctrl-0 = <&hsusb2_pins>;
        port2-mode = "ehci-phy";
 };
 
@@ -151,10 +155,7 @@
        phys = <0 &hsusb2_phy>;
 };
 
-
 &omap3_pmx_core {
-       pinctrl-names = "default";
-       pinctrl-0 = <&hsusb2_pins>;
 
        mmc3_pins: pinmux_mm3_pins {
                pinctrl-single,pins = <
@@ -250,8 +251,7 @@
 };
 
 &omap3_pmx_wkup {
-       pinctrl-names = "default";
-       pinctrl-0 = <&hsusb2_reset_pin>;
+
        hsusb2_reset_pin: pinmux_hsusb1_reset_pin {
                pinctrl-single,pins = <
                        OMAP3_WKUP_IOPAD(0x2a0e, PIN_OUTPUT | MUX_MODE4)        /* sys_boot2.gpio_4 */