On the production revision of the SoM, 587-200, the PHY reset GPIO and
touchscreen IRQs are swapped to prevent collision between EXTi IRQs,
reflect that in DT.
Fixes:
34e0c7847dcf ("ARM: dts: stm32: Add DH Electronics DHCOM STM32MP1 SoM and PDK2 board")
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Alexandre Torgue <alexandre.torgue@st.com>
Cc: Maxime Coquelin <mcoquelin.stm32@gmail.com>
Cc: Patrice Chotard <patrice.chotard@st.com>
Cc: Patrick Delaunay <patrick.delaunay@st.com>
Cc: linux-stm32@st-md-mailman.stormreply.com
To: linux-arm-kernel@lists.infradead.org
Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>
max-speed = <100>;
phy-handle = <&phy0>;
st,eth-ref-clk-sel;
- phy-reset-gpios = <&gpioh 15 GPIO_ACTIVE_LOW>;
+ phy-reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>;
mdio0 {
#address-cells = <1>;
compatible = "ti,tsc2004";
reg = <0x49>;
vio-supply = <&v3v3>;
- interrupts-extended = <&gpioh 3 IRQ_TYPE_EDGE_FALLING>;
+ interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>;
};
eeprom@50 {