mac80211: initialize SMPS field in HT capabilities

ibss and mesh modes copy the ht capabilites from the band without
overriding the SMPS state. Unfortunately the default value 0 for the
SMPS field means static SMPS instead of disabled.

This results in HT ibss and mesh setups using only single-stream rates,
even though SMPS is not supposed to be active.

Initialize SMPS to disabled for all bands on ieee80211_hw_register to
ensure that the value is sane where it is not overriden with the real
SMPS state.

Reported-by: Elektra Wagenrad <onelektra@gmx.net>
Signed-off-by: Felix Fietkau <nbd@nbd.name>
[move VHT TODO comment to a better place]
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

diff --git a/net/mac80211/main.c b/net/mac80211/main.c
index 1822c77..56fb479 100644 (file)
--- a/net/mac80211/main.c
+++ b/net/mac80211/main.c
@@ -913,12 +913,17 @@ int ieee80211_register_hw(struct ieee80211_hw *hw)
                supp_ht = supp_ht || sband->ht_cap.ht_supported;
                supp_vht = supp_vht || sband->vht_cap.vht_supported;
 
-               if (sband->ht_cap.ht_supported)
-                       local->rx_chains =
-                               max(ieee80211_mcs_to_chains(&sband->ht_cap.mcs),
-                                   local->rx_chains);
+               if (!sband->ht_cap.ht_supported)
+                       continue;
 
                /* TODO: consider VHT for RX chains, hopefully it's the same */
+               local->rx_chains =
+                       max(ieee80211_mcs_to_chains(&sband->ht_cap.mcs),
+                           local->rx_chains);
+
+               /* no need to mask, SM_PS_DISABLED has all bits set */
+               sband->ht_cap.cap |= WLAN_HT_CAP_SM_PS_DISABLED <<
+                                    IEEE80211_HT_CAP_SM_PS_SHIFT;
        }
 
        /* if low-level driver supports AP, we also support VLAN */