1 // SPDX-License-Identifier: GPL-2.0
2 // Copyright (c) 2010-2011 Samsung Electronics Co., Ltd.
3 // http://www.samsung.com
5 // Cloned from linux/arch/arm/mach-vexpress/platsmp.c
7 // Copyright (C) 2002 ARM Ltd.
10 #include <linux/init.h>
11 #include <linux/errno.h>
12 #include <linux/delay.h>
13 #include <linux/jiffies.h>
14 #include <linux/smp.h>
16 #include <linux/of_address.h>
17 #include <linux/soc/samsung/exynos-regs-pmu.h>
19 #include <asm/cacheflush.h>
21 #include <asm/smp_plat.h>
22 #include <asm/smp_scu.h>
23 #include <asm/firmware.h>
27 extern void exynos4_secondary_startup(void);
29 /* XXX exynos_pen_release is cargo culted code - DO NOT COPY XXX */
30 volatile int exynos_pen_release = -1;
32 #ifdef CONFIG_HOTPLUG_CPU
33 static inline void cpu_leave_lowpower(u32 core_id)
38 "mrc p15, 0, %0, c1, c0, 0\n"
40 " mcr p15, 0, %0, c1, c0, 0\n"
41 " mrc p15, 0, %0, c1, c0, 1\n"
43 " mcr p15, 0, %0, c1, c0, 1\n"
45 : "Ir" (CR_C), "Ir" (0x40)
49 static inline void platform_do_lowpower(unsigned int cpu, int *spurious)
51 u32 mpidr = cpu_logical_map(cpu);
52 u32 core_id = MPIDR_AFFINITY_LEVEL(mpidr, 0);
56 /* Turn the CPU off on next WFI instruction. */
57 exynos_cpu_power_down(core_id);
61 if (exynos_pen_release == core_id) {
63 * OK, proper wakeup, we're done
69 * Getting here, means that we have come out of WFI without
70 * having been woken up - this shouldn't happen
72 * Just note it happening - when we're woken, we can report
78 #endif /* CONFIG_HOTPLUG_CPU */
81 * exynos_cpu_power_down() - power down the specified cpu
82 * @cpu: the cpu to power down
84 * Power down the specified cpu. The sequence must be finished by a
85 * call to cpu_do_idle()
87 void exynos_cpu_power_down(int cpu)
91 if (cpu == 0 && (soc_is_exynos5420() || soc_is_exynos5800())) {
93 * Bypass power down for CPU0 during suspend. Check for
94 * the SYS_PWR_REG value to decide if we are suspending
97 int val = pmu_raw_readl(EXYNOS5_ARM_CORE0_SYS_PWR_REG);
99 if (!(val & S5P_CORE_LOCAL_PWR_EN))
103 core_conf = pmu_raw_readl(EXYNOS_ARM_CORE_CONFIGURATION(cpu));
104 core_conf &= ~S5P_CORE_LOCAL_PWR_EN;
105 pmu_raw_writel(core_conf, EXYNOS_ARM_CORE_CONFIGURATION(cpu));
109 * exynos_cpu_power_up() - power up the specified cpu
110 * @cpu: the cpu to power up
112 * Power up the specified cpu
114 void exynos_cpu_power_up(int cpu)
116 u32 core_conf = S5P_CORE_LOCAL_PWR_EN;
118 if (soc_is_exynos3250())
119 core_conf |= S5P_CORE_AUTOWAKEUP_EN;
121 pmu_raw_writel(core_conf,
122 EXYNOS_ARM_CORE_CONFIGURATION(cpu));
126 * exynos_cpu_power_state() - returns the power state of the cpu
127 * @cpu: the cpu to retrieve the power state from
129 int exynos_cpu_power_state(int cpu)
131 return (pmu_raw_readl(EXYNOS_ARM_CORE_STATUS(cpu)) &
132 S5P_CORE_LOCAL_PWR_EN);
136 * exynos_cluster_power_down() - power down the specified cluster
137 * @cluster: the cluster to power down
139 void exynos_cluster_power_down(int cluster)
141 pmu_raw_writel(0, EXYNOS_COMMON_CONFIGURATION(cluster));
145 * exynos_cluster_power_up() - power up the specified cluster
146 * @cluster: the cluster to power up
148 void exynos_cluster_power_up(int cluster)
150 pmu_raw_writel(S5P_CORE_LOCAL_PWR_EN,
151 EXYNOS_COMMON_CONFIGURATION(cluster));
155 * exynos_cluster_power_state() - returns the power state of the cluster
156 * @cluster: the cluster to retrieve the power state from
159 int exynos_cluster_power_state(int cluster)
161 return (pmu_raw_readl(EXYNOS_COMMON_STATUS(cluster)) &
162 S5P_CORE_LOCAL_PWR_EN);
166 * exynos_scu_enable() - enables SCU for Cortex-A9 based system
168 void exynos_scu_enable(void)
170 struct device_node *np;
171 static void __iomem *scu_base;
174 np = of_find_compatible_node(NULL, NULL, "arm,cortex-a9-scu");
176 scu_base = of_iomap(np, 0);
179 scu_base = ioremap(scu_a9_get_base(), SZ_4K);
182 scu_enable(scu_base);
185 static void __iomem *cpu_boot_reg_base(void)
187 if (soc_is_exynos4210() && exynos_rev() == EXYNOS4210_REV_1_1)
188 return pmu_base_addr + S5P_INFORM5;
189 return sysram_base_addr;
192 static inline void __iomem *cpu_boot_reg(int cpu)
194 void __iomem *boot_reg;
196 boot_reg = cpu_boot_reg_base();
198 return IOMEM_ERR_PTR(-ENODEV);
199 if (soc_is_exynos4412())
201 else if (soc_is_exynos5420() || soc_is_exynos5800())
207 * Set wake up by local power mode and execute software reset for given core.
209 * Currently this is needed only when booting secondary CPU on Exynos3250.
211 void exynos_core_restart(u32 core_id)
213 unsigned int timeout = 16;
216 if (!soc_is_exynos3250())
219 while (timeout && !pmu_raw_readl(S5P_PMU_SPARE2)) {
224 pr_err("cpu core %u restart failed\n", core_id);
229 val = pmu_raw_readl(EXYNOS_ARM_CORE_STATUS(core_id));
230 val |= S5P_CORE_WAKEUP_FROM_LOCAL_CFG;
231 pmu_raw_writel(val, EXYNOS_ARM_CORE_STATUS(core_id));
233 pmu_raw_writel(EXYNOS_CORE_PO_RESET(core_id), EXYNOS_SWRESET);
237 * XXX CARGO CULTED CODE - DO NOT COPY XXX
239 * Write exynos_pen_release in a way that is guaranteed to be visible to
240 * all observers, irrespective of whether they're taking part in coherency
241 * or not. This is necessary for the hotplug code to work reliably.
243 static void exynos_write_pen_release(int val)
245 exynos_pen_release = val;
247 sync_cache_w(&exynos_pen_release);
250 static DEFINE_SPINLOCK(boot_lock);
252 static void exynos_secondary_init(unsigned int cpu)
255 * let the primary processor know we're out of the
256 * pen, then head off into the C entry point
258 exynos_write_pen_release(-1);
261 * Synchronise with the boot thread.
263 spin_lock(&boot_lock);
264 spin_unlock(&boot_lock);
267 int exynos_set_boot_addr(u32 core_id, unsigned long boot_addr)
272 * Try to set boot address using firmware first
273 * and fall back to boot register if it fails.
275 ret = call_firmware_op(set_cpu_boot_addr, core_id, boot_addr);
276 if (ret && ret != -ENOSYS)
278 if (ret == -ENOSYS) {
279 void __iomem *boot_reg = cpu_boot_reg(core_id);
281 if (IS_ERR(boot_reg)) {
282 ret = PTR_ERR(boot_reg);
285 writel_relaxed(boot_addr, boot_reg);
292 int exynos_get_boot_addr(u32 core_id, unsigned long *boot_addr)
297 * Try to get boot address using firmware first
298 * and fall back to boot register if it fails.
300 ret = call_firmware_op(get_cpu_boot_addr, core_id, boot_addr);
301 if (ret && ret != -ENOSYS)
303 if (ret == -ENOSYS) {
304 void __iomem *boot_reg = cpu_boot_reg(core_id);
306 if (IS_ERR(boot_reg)) {
307 ret = PTR_ERR(boot_reg);
310 *boot_addr = readl_relaxed(boot_reg);
317 static int exynos_boot_secondary(unsigned int cpu, struct task_struct *idle)
319 unsigned long timeout;
320 u32 mpidr = cpu_logical_map(cpu);
321 u32 core_id = MPIDR_AFFINITY_LEVEL(mpidr, 0);
325 * Set synchronisation state between this boot processor
326 * and the secondary one
328 spin_lock(&boot_lock);
331 * The secondary processor is waiting to be released from
332 * the holding pen - release it, then wait for it to flag
333 * that it has been released by resetting exynos_pen_release.
335 * Note that "exynos_pen_release" is the hardware CPU core ID, whereas
336 * "cpu" is Linux's internal ID.
338 exynos_write_pen_release(core_id);
340 if (!exynos_cpu_power_state(core_id)) {
341 exynos_cpu_power_up(core_id);
344 /* wait max 10 ms until cpu1 is on */
345 while (exynos_cpu_power_state(core_id)
346 != S5P_CORE_LOCAL_PWR_EN) {
354 printk(KERN_ERR "cpu1 power enable failed");
355 spin_unlock(&boot_lock);
360 exynos_core_restart(core_id);
363 * Send the secondary CPU a soft interrupt, thereby causing
364 * the boot monitor to read the system wide flags register,
365 * and branch to the address found there.
368 timeout = jiffies + (1 * HZ);
369 while (time_before(jiffies, timeout)) {
370 unsigned long boot_addr;
374 boot_addr = __pa_symbol(exynos4_secondary_startup);
376 ret = exynos_set_boot_addr(core_id, boot_addr);
380 call_firmware_op(cpu_boot, core_id);
382 if (soc_is_exynos3250())
385 arch_send_wakeup_ipi_mask(cpumask_of(cpu));
387 if (exynos_pen_release == -1)
393 if (exynos_pen_release != -1)
397 * now the secondary core is starting up let it run its
398 * calibrations, then wait for it to finish
401 spin_unlock(&boot_lock);
403 return exynos_pen_release != -1 ? ret : 0;
406 static void __init exynos_smp_prepare_cpus(unsigned int max_cpus)
408 exynos_sysram_init();
410 exynos_set_delayed_reset_assertion(true);
412 if (read_cpuid_part() == ARM_CPU_PART_CORTEX_A9)
416 #ifdef CONFIG_HOTPLUG_CPU
418 * platform-specific code to shutdown a CPU
420 * Called with IRQs disabled
422 static void exynos_cpu_die(unsigned int cpu)
425 u32 mpidr = cpu_logical_map(cpu);
426 u32 core_id = MPIDR_AFFINITY_LEVEL(mpidr, 0);
428 v7_exit_coherency_flush(louis);
430 platform_do_lowpower(cpu, &spurious);
433 * bring this CPU back into the world of cache
434 * coherency, and then restore interrupts
436 cpu_leave_lowpower(core_id);
439 pr_warn("CPU%u: %u spurious wakeup calls\n", cpu, spurious);
441 #endif /* CONFIG_HOTPLUG_CPU */
443 const struct smp_operations exynos_smp_ops __initconst = {
444 .smp_prepare_cpus = exynos_smp_prepare_cpus,
445 .smp_secondary_init = exynos_secondary_init,
446 .smp_boot_secondary = exynos_boot_secondary,
447 #ifdef CONFIG_HOTPLUG_CPU
448 .cpu_die = exynos_cpu_die,