#include <asm/special_insns.h>
#include <asm/smp.h>
#include <asm/invpcid.h>
+#include <asm/pti.h>
+#include <asm/processor-flags.h>
-static inline u64 inc_mm_tlb_gen(struct mm_struct *mm)
-{
- /*
- * Bump the generation count. This also serves as a full barrier
- * that synchronizes with switch_mm(): callers are required to order
- * their read of mm_cpumask after their writes to the paging
- * structures.
- */
- return atomic64_inc_return(&mm->context.tlb_gen);
-}
+/*
+ * The x86 feature is called PCID (Process Context IDentifier). It is similar
+ * to what is traditionally called ASID on the RISC processors.
+ *
+ * We don't use the traditional ASID implementation, where each process/mm gets
+ * its own ASID and flush/restart when we run out of ASID space.
+ *
+ * Instead we have a small per-cpu array of ASIDs and cache the last few mm's
+ * that came by on this CPU, allowing cheaper switch_mm between processes on
+ * this CPU.
+ *
+ * We end up with different spaces for different things. To avoid confusion we
+ * use different names for each of them:
+ *
+ * ASID - [0, TLB_NR_DYN_ASIDS-1]
+ * the canonical identifier for an mm
+ *
+ * kPCID - [1, TLB_NR_DYN_ASIDS]
+ * the value we write into the PCID part of CR3; corresponds to the
+ * ASID+1, because PCID 0 is special.
+ *
+ * uPCID - [2048 + 1, 2048 + TLB_NR_DYN_ASIDS]
+ * for KPTI each mm has two address spaces and thus needs two
+ * PCID values, but we can still do with a single ASID denomination
+ * for each mm. Corresponds to kPCID + 2048.
+ *
+ */
/* There are 12 bits of space for ASIDS in CR3 */
#define CR3_HW_ASID_BITS 12
+
/*
* When enabled, PAGE_TABLE_ISOLATION consumes a single bit for
* user/kernel switches
*/
-#define PTI_CONSUMED_ASID_BITS 0
+#ifdef CONFIG_PAGE_TABLE_ISOLATION
+# define PTI_CONSUMED_PCID_BITS 1
+#else
+# define PTI_CONSUMED_PCID_BITS 0
+#endif
+
+#define CR3_AVAIL_PCID_BITS (X86_CR3_PCID_BITS - PTI_CONSUMED_PCID_BITS)
-#define CR3_AVAIL_ASID_BITS (CR3_HW_ASID_BITS - PTI_CONSUMED_ASID_BITS)
/*
* ASIDs are zero-based: 0->MAX_AVAIL_ASID are valid. -1 below to account
- * for them being zero-based. Another -1 is because ASID 0 is reserved for
+ * for them being zero-based. Another -1 is because PCID 0 is reserved for
* use by non-PCID-aware users.
*/
-#define MAX_ASID_AVAILABLE ((1 << CR3_AVAIL_ASID_BITS) - 2)
+#define MAX_ASID_AVAILABLE ((1 << CR3_AVAIL_PCID_BITS) - 2)
+/*
+ * 6 because 6 should be plenty and struct tlb_state will fit in two cache
+ * lines.
+ */
+#define TLB_NR_DYN_ASIDS 6
+
+/*
+ * Given @asid, compute kPCID
+ */
static inline u16 kern_pcid(u16 asid)
{
VM_WARN_ON_ONCE(asid > MAX_ASID_AVAILABLE);
+
+#ifdef CONFIG_PAGE_TABLE_ISOLATION
+ /*
+ * Make sure that the dynamic ASID space does not confict with the
+ * bit we are using to switch between user and kernel ASIDs.
+ */
+ BUILD_BUG_ON(TLB_NR_DYN_ASIDS >= (1 << X86_CR3_PTI_SWITCH_BIT));
+
+ /*
+ * The ASID being passed in here should have respected the
+ * MAX_ASID_AVAILABLE and thus never have the switch bit set.
+ */
+ VM_WARN_ON_ONCE(asid & (1 << X86_CR3_PTI_SWITCH_BIT));
+#endif
/*
+ * The dynamically-assigned ASIDs that get passed in are small
+ * (<TLB_NR_DYN_ASIDS). They never have the high switch bit set,
+ * so do not bother to clear it.
+ *
* If PCID is on, ASID-aware code paths put the ASID+1 into the
* PCID bits. This serves two purposes. It prevents a nasty
* situation in which PCID-unaware code saves CR3, loads some other
return asid + 1;
}
+/*
+ * Given @asid, compute uPCID
+ */
+static inline u16 user_pcid(u16 asid)
+{
+ u16 ret = kern_pcid(asid);
+#ifdef CONFIG_PAGE_TABLE_ISOLATION
+ ret |= 1 << X86_CR3_PTI_SWITCH_BIT;
+#endif
+ return ret;
+}
+
struct pgd_t;
static inline unsigned long build_cr3(pgd_t *pgd, u16 asid)
{
return !static_cpu_has(X86_FEATURE_PCID);
}
-/*
- * 6 because 6 should be plenty and struct tlb_state will fit in
- * two cache lines.
- */
-#define TLB_NR_DYN_ASIDS 6
-
struct tlb_context {
u64 ctx_id;
u64 tlb_gen;
*/
bool is_lazy;
+ /*
+ * If set we changed the page tables in such a way that we
+ * needed an invalidation of all contexts (aka. PCIDs / ASIDs).
+ * This tells us to go invalidate all the non-loaded ctxs[]
+ * on the next context switch.
+ *
+ * The current ctx was kept up-to-date as it ran and does not
+ * need to be invalidated.
+ */
+ bool invalidate_other;
+
+ /*
+ * Mask that contains TLB_NR_DYN_ASIDS+1 bits to indicate
+ * the corresponding user PCID needs a flush next time we
+ * switch to it; see SWITCH_TO_USER_CR3.
+ */
+ unsigned short user_pcid_flush_mask;
+
/*
* Access to this CR4 shadow and to H/W CR4 is protected by
* disabling interrupts when modifying either one.
return this_cpu_read(cpu_tlbstate.cr4);
}
+/*
+ * Mark all other ASIDs as invalid, preserves the current.
+ */
+static inline void invalidate_other_asid(void)
+{
+ this_cpu_write(cpu_tlbstate.invalidate_other, true);
+}
+
/*
* Save some of cr4 feature set we're using (e.g. Pentium 4MB
* enable and PPro Global page enable), so that any CPU's that boot
extern void initialize_tlbstate_and_flush(void);
+/*
+ * Given an ASID, flush the corresponding user ASID. We can delay this
+ * until the next time we switch to it.
+ *
+ * See SWITCH_TO_USER_CR3.
+ */
+static inline void invalidate_user_asid(u16 asid)
+{
+ /* There is no user ASID if address space separation is off */
+ if (!IS_ENABLED(CONFIG_PAGE_TABLE_ISOLATION))
+ return;
+
+ /*
+ * We only have a single ASID if PCID is off and the CR3
+ * write will have flushed it.
+ */
+ if (!cpu_feature_enabled(X86_FEATURE_PCID))
+ return;
+
+ if (!static_cpu_has(X86_FEATURE_PTI))
+ return;
+
+ __set_bit(kern_pcid(asid),
+ (unsigned long *)this_cpu_ptr(&cpu_tlbstate.user_pcid_flush_mask));
+}
+
/*
* flush the entire current user mapping
*/
static inline void __native_flush_tlb(void)
{
+ invalidate_user_asid(this_cpu_read(cpu_tlbstate.loaded_mm_asid));
/*
- * If current->mm == NULL then we borrow a mm which may change during a
- * task switch and therefore we must not be preempted while we write CR3
- * back:
+ * If current->mm == NULL then we borrow a mm which may change
+ * during a task switch and therefore we must not be preempted
+ * while we write CR3 back:
*/
preempt_disable();
native_write_cr3(__native_read_cr3());
/*
* Using INVPCID is considerably faster than a pair of writes
* to CR4 sandwiched inside an IRQ flag save/restore.
+ *
+ * Note, this works with CR4.PCIDE=0 or 1.
*/
invpcid_flush_all();
return;
*/
static inline void __native_flush_tlb_single(unsigned long addr)
{
+ u32 loaded_mm_asid = this_cpu_read(cpu_tlbstate.loaded_mm_asid);
+
asm volatile("invlpg (%0)" ::"r" (addr) : "memory");
+
+ if (!static_cpu_has(X86_FEATURE_PTI))
+ return;
+
+ /*
+ * Some platforms #GP if we call invpcid(type=1/2) before CR4.PCIDE=1.
+ * Just use invalidate_user_asid() in case we are called early.
+ */
+ if (!this_cpu_has(X86_FEATURE_INVPCID_SINGLE))
+ invalidate_user_asid(loaded_mm_asid);
+ else
+ invpcid_flush_one(user_pcid(loaded_mm_asid), addr);
}
/*
*/
__flush_tlb();
}
-
- /*
- * Note: if we somehow had PCID but not PGE, then this wouldn't work --
- * we'd end up flushing kernel translations for the current ASID but
- * we might fail to flush kernel translations for other cached ASIDs.
- *
- * To avoid this issue, we force PCID off if PGE is off.
- */
}
/*
{
count_vm_tlb_event(NR_TLB_LOCAL_FLUSH_ONE);
__flush_tlb_single(addr);
+
+ if (!static_cpu_has(X86_FEATURE_PTI))
+ return;
+
+ /*
+ * __flush_tlb_single() will have cleared the TLB entry for this ASID,
+ * but since kernel space is replicated across all, we must also
+ * invalidate all others.
+ */
+ invalidate_other_asid();
}
#define TLB_FLUSH_ALL -1UL
void native_flush_tlb_others(const struct cpumask *cpumask,
const struct flush_tlb_info *info);
+static inline u64 inc_mm_tlb_gen(struct mm_struct *mm)
+{
+ /*
+ * Bump the generation count. This also serves as a full barrier
+ * that synchronizes with switch_mm(): callers are required to order
+ * their read of mm_cpumask after their writes to the paging
+ * structures.
+ */
+ return atomic64_inc_return(&mm->context.tlb_gen);
+}
+
static inline void arch_tlbbatch_add_mm(struct arch_tlbflush_unmap_batch *batch,
struct mm_struct *mm)
{
projects / linux-2.6-microblaze.git / blobdiff