clock-names = "du.0", "du.1", "du.2", "du.3",
"dclkin.0", "dclkin.1", "dclkin.2", "dclkin.3";
};
-
-&ehci2 {
- status = "okay";
-};
-
-&ehci3 {
- dr_mode = "otg";
- status = "okay";
-};
-
-&hsusb3 {
- dr_mode = "otg";
- status = "okay";
-};
-
-&ohci2 {
- status = "okay";
-};
-
-&ohci3 {
- dr_mode = "otg";
- status = "okay";
-};
-
-&pca9654 {
- pcie-sata-switch-hog {
- gpio-hog;
- gpios = <7 GPIO_ACTIVE_HIGH>;
- output-low; /* enable SATA by default */
- line-name = "PCIE/SATA switch";
- };
-};
-
-&pfc {
- usb2_pins: usb2 {
- groups = "usb2";
- function = "usb2";
- };
-
- /*
- * - On Salvator-X[S], GP6_3[01] are connected to ADV7482 as irq pins
- * (when SW31 is the default setting on Salvator-XS).
- * - If SW31 is the default setting, you cannot use USB2.0 ch3 on
- * r8a77951 with Salvator-XS.
- * Hence the SW31 setting must be changed like 2) below.
- * 1) Default setting of SW31: ON-ON-OFF-OFF-OFF-OFF:
- * - Connect GP6_3[01] to ADV7842.
- * 2) Changed setting of SW31: OFF-OFF-ON-ON-ON-ON:
- * - Connect GP6_3[01] to BD082065 (USB2.0 ch3's host power).
- * - Connect GP6_{04,21} to ADV7842.
- */
- usb2_ch3_pins: usb2_ch3 {
- groups = "usb2_ch3";
- function = "usb2_ch3";
- };
-};
-
-/* SW12-7 must be set 'Off' (MD12 set to 1) which is not the default! */
-&sata {
- status = "okay";
-};
-
-&usb2_phy2 {
- pinctrl-0 = <&usb2_pins>;
- pinctrl-names = "default";
-
- status = "okay";
-};
-
-&usb2_phy3 {
- pinctrl-0 = <&usb2_ch3_pins>;
- pinctrl-names = "default";
-
- status = "okay";
-};