dt-bindings: mediatek: add mt7623 display-nodes

[linux-2.6-microblaze.git] / Documentation / devicetree / bindings / display / mediatek / mediatek,hdmi.txt

diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,hdmi.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,hdmi.txt
index 7b12424..6b1c586 100644 (file)
--- a/Documentation/devicetree/bindings/display/mediatek/mediatek,hdmi.txt
+++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,hdmi.txt
@@ -6,6 +6,7 @@ its parallel input.
 
 Required properties:
 - compatible: Should be "mediatek,<chip>-hdmi".
+- the supported chips are mt2701, mt7623 and mt8173
 - reg: Physical base address and length of the controller's registers
 - interrupts: The interrupt signal from the function block.
 - clocks: device clocks
@@ -32,6 +33,7 @@ The HDMI CEC controller handles hotplug detection and CEC communication.
 
 Required properties:
 - compatible: Should be "mediatek,<chip>-cec"
+- the supported chips are mt7623 and mt8173
 - reg: Physical base address and length of the controller's registers
 - interrupts: The interrupt signal from the function block.
 - clocks: device clock
@@ -44,6 +46,7 @@ The Mediatek's I2C controller is used to interface with I2C devices.
 
 Required properties:
 - compatible: Should be "mediatek,<chip>-hdmi-ddc"
+- the supported chips are mt7623 and mt8173
 - reg: Physical base address and length of the controller's registers
 - clocks: device clock
 - clock-names: Should be "ddc-i2c".
@@ -56,6 +59,7 @@ output and drives the HDMI pads.
 
 Required properties:
 - compatible: "mediatek,<chip>-hdmi-phy"
+- the supported chips are mt2701, mt7623 and mt8173
 - reg: Physical base address and length of the module's registers
 - clocks: PLL reference clock
 - clock-names: must contain "pll_ref"