From: Raul E Rangel Date: Mon, 29 Apr 2019 17:32:39 +0000 (-0600) Subject: mmc: core: Verify SD bus width X-Git-Tag: microblaze-v5.4-rc1~809^2~12 X-Git-Url: http://git.monstr.eu/?a=commitdiff_plain;h=9e4be8d03f50d1b25c38e2b59e73b194c130df7d;p=linux-2.6-microblaze.git mmc: core: Verify SD bus width The SD Physical Layer Spec says the following: Since the SD Memory Card shall support at least the two bus modes 1-bit or 4-bit width, then any SD Card shall set at least bits 0 and 2 (SD_BUS_WIDTH="0101"). This change verifies the card has specified a bus width. AMD SDHC Device 7806 can get into a bad state after a card disconnect where anything transferred via the DATA lines will always result in a zero filled buffer. Currently the driver will continue without error if the HC is in this condition. A block device will be created, but reading from it will result in a zero buffer. This makes it seem like the SD device has been erased, when in actuality the data is never getting copied from the DATA lines to the data buffer. SCR is the first command in the SD initialization sequence that uses the DATA lines. By checking that the response was invalid, we can abort mounting the card. Reviewed-by: Avri Altman Signed-off-by: Raul E Rangel Signed-off-by: Ulf Hansson --- diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c index 265e1aeeb9d8..d3d32f9a2cb1 100644 --- a/drivers/mmc/core/sd.c +++ b/drivers/mmc/core/sd.c @@ -221,6 +221,14 @@ static int mmc_decode_scr(struct mmc_card *card) if (scr->sda_spec3) scr->cmds = UNSTUFF_BITS(resp, 32, 2); + + /* SD Spec says: any SD Card shall set at least bits 0 and 2 */ + if (!(scr->bus_widths & SD_SCR_BUS_WIDTH_1) || + !(scr->bus_widths & SD_SCR_BUS_WIDTH_4)) { + pr_err("%s: invalid bus width\n", mmc_hostname(card->host)); + return -EINVAL; + } + return 0; }