i2c: designware: Adjust bus_freq_hz when refuse high speed mode set

When hardware doesn't support High Speed Mode, we forget bus_freq_hz
timing adjustment. This makes the timings and real registers being
unsynchronized. Adjust bus_freq_hz when refuse high speed mode set.

Fixes: b6e67145f149 ("i2c: designware: Enable high speed mode")
Reported-by: "Song Bao Hua (Barry Song)" <song.bao.hua@hisilicon.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Barry Song <song.bao.hua@hisilicon.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

diff --git a/drivers/i2c/busses/i2c-designware-master.c b/drivers/i2c/busses/i2c-designware-master.c
index dd27b9d..873ef38 100644 (file)
--- a/drivers/i2c/busses/i2c-designware-master.c
+++ b/drivers/i2c/busses/i2c-designware-master.c
@@ -129,6 +129,7 @@ static int i2c_dw_set_timings_master(struct dw_i2c_dev *dev)
                if ((comp_param1 & DW_IC_COMP_PARAM_1_SPEED_MODE_MASK)
                        != DW_IC_COMP_PARAM_1_SPEED_MODE_HIGH) {
                        dev_err(dev->dev, "High Speed not supported!\n");
+                       t->bus_freq_hz = I2C_MAX_FAST_MODE_FREQ;
                        dev->master_cfg &= ~DW_IC_CON_SPEED_MASK;
                        dev->master_cfg |= DW_IC_CON_SPEED_FAST;
                        dev->hs_hcnt = 0;