For some cases as below, we may encounter the unpreditable chip stats
in driver probe()
* The system reboot flow do not work properly, such as kernel oops while
rebooting, and then the driver do not go back to default status at
this moment.
* Similar to the flow above. If the device was enabled in BIOS or UEFI,
the system may switch to Linux without driver fully shutdown.
To avoid the problem, force push the device back to default in probe()
* mt7921e_mcu_fw_pmctrl() : return control privilege to chip side.
* mt7921_wfsys_reset() : cleanup chip config before resource init.
Error log
[59007.600714] mt7921e 0000:02:00.0: ASIC revision:
79220010
[59010.889773] mt7921e 0000:02:00.0: Message
00000010 (seq 1) timeout
[59010.889786] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59014.217839] mt7921e 0000:02:00.0: Message
00000010 (seq 2) timeout
[59014.217852] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59017.545880] mt7921e 0000:02:00.0: Message
00000010 (seq 3) timeout
[59017.545893] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59020.874086] mt7921e 0000:02:00.0: Message
00000010 (seq 4) timeout
[59020.874099] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59024.202019] mt7921e 0000:02:00.0: Message
00000010 (seq 5) timeout
[59024.202033] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59027.530082] mt7921e 0000:02:00.0: Message
00000010 (seq 6) timeout
[59027.530096] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59030.857888] mt7921e 0000:02:00.0: Message
00000010 (seq 7) timeout
[59030.857904] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59034.185946] mt7921e 0000:02:00.0: Message
00000010 (seq 8) timeout
[59034.185961] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59037.514249] mt7921e 0000:02:00.0: Message
00000010 (seq 9) timeout
[59037.514262] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59040.842362] mt7921e 0000:02:00.0: Message
00000010 (seq 10) timeout
[59040.842375] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59040.923845] mt7921e 0000:02:00.0: hardware init failed
Cc: stable@vger.kernel.org
Fixes:
5c14a5f944b9 ("mt76: mt7921: introduce mt7921e support")
Tested-by: Kai-Heng Feng <kai.heng.feng@canonical.com>
Tested-by: Juan Martinez <juan.martinez@amd.com>
Co-developed-by: Leon Yen <leon.yen@mediatek.com>
Signed-off-by: Leon Yen <leon.yen@mediatek.com>
Signed-off-by: Quan Zhou <quan.zhou@mediatek.com>
Signed-off-by: Deren Wu <deren.wu@mediatek.com>
Message-ID: <
39fcb7cee08d4ab940d38d82f21897483212483f.
1688569385.git.deren.wu@mediatek.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
if (ret)
return ret;
- ret = mt7921_wfsys_reset(dev);
- if (ret)
- return ret;
-
/* init tx queue */
ret = mt76_connac_init_tx_queues(dev->phy.mt76, MT7921_TXQ_BAND0,
MT7921_TX_RING_SIZE,
{
int ret;
- ret = mt76_get_field(dev, MT_CONN_ON_MISC, MT_TOP_MISC2_FW_N9_RDY);
- if (ret && mt76_is_mmio(&dev->mt76)) {
- dev_dbg(dev->mt76.dev, "Firmware is already download\n");
- goto fw_loaded;
- }
-
ret = mt76_connac2_load_patch(&dev->mt76, mt7921_patch_name(dev));
if (ret)
return ret;
return -EIO;
}
-fw_loaded:
-
#ifdef CONFIG_PM
dev->mt76.hw->wiphy->wowlan = &mt76_connac_wowlan_support;
#endif /* CONFIG_PM */
bus_ops->rmw = mt7921_rmw;
dev->mt76.bus = bus_ops;
+ ret = mt7921e_mcu_fw_pmctrl(dev);
+ if (ret)
+ goto err_free_dev;
+
ret = __mt7921e_mcu_drv_pmctrl(dev);
if (ret)
goto err_free_dev;
(mt7921_l1_rr(dev, MT_HW_REV) & 0xff);
dev_info(mdev->dev, "ASIC revision: %04x\n", mdev->rev);
+ ret = mt7921_wfsys_reset(dev);
+ if (ret)
+ goto err_free_dev;
+
mt76_wr(dev, MT_WFDMA0_HOST_INT_ENA, 0);
mt76_wr(dev, MT_PCIE_MAC_INT_ENABLE, 0xff);