dt-bindings: phy: add DT binding for Microsemi Ocelot SerDes muxing
authorQuentin Schulz <quentin.schulz@bootlin.com>
Thu, 4 Oct 2018 12:22:04 +0000 (14:22 +0200)
committerDavid S. Miller <davem@davemloft.net>
Fri, 5 Oct 2018 21:36:44 +0000 (14:36 -0700)
Signed-off-by: Quentin Schulz <quentin.schulz@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt [new file with mode: 0644]

diff --git a/Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt b/Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt
new file mode 100644 (file)
index 0000000..3322198
--- /dev/null
@@ -0,0 +1,43 @@
+Microsemi Ocelot SerDes muxing driver
+-------------------------------------
+
+On Microsemi Ocelot, there is a handful of registers in HSIO address
+space for setting up the SerDes to switch port muxing.
+
+A SerDes X can be "muxed" to work with switch port Y or Z for example.
+One specific SerDes can also be used as a PCIe interface.
+
+Hence, a SerDes represents an interface, be it an Ethernet or a PCIe one.
+
+There are two kinds of SerDes: SERDES1G supports 10/100Mbps in
+half/full-duplex and 1000Mbps in full-duplex mode while SERDES6G supports
+10/100Mbps in half/full-duplex and 1000/2500Mbps in full-duplex mode.
+
+Also, SERDES6G number (aka "macro") 0 is the only interface supporting
+QSGMII.
+
+This is a child of the HSIO syscon ("mscc,ocelot-hsio", see
+Documentation/devicetree/bindings/mips/mscc.txt) on the Microsemi Ocelot.
+
+Required properties:
+
+- compatible: should be "mscc,vsc7514-serdes"
+- #phy-cells : from the generic phy bindings, must be 2.
+              The first number defines the input port to use for a given
+              SerDes macro. The second defines the macro to use. They are
+              defined in dt-bindings/phy/phy-ocelot-serdes.h
+
+Example:
+
+       serdes: serdes {
+               compatible = "mscc,vsc7514-serdes";
+               #phy-cells = <2>;
+       };
+
+       ethernet {
+               port1 {
+                       phy-handle = <&phy_foo>;
+                       /* Link SERDES1G_5 to port1 */
+                       phys = <&serdes 1 SERDES1G_5>;
+               };
+       };