arm64: zynqmp: Fix usb reset over bootmode pins on zcu100

The commit 53ba1b2bdaf7 ("arm64: dts: zynqmp: Add mode-pin GPIO controller
DT node") added usb phy reset over bootmode pins by default on usb0 only.
zcu100 is using usb0 as peripheral and usb1 as host. Unfortunately reset
line is shared for both usb ulpi phys but usb_rst_b is connected to usb5744
hub which is used only in host mode. Especially this chip requires reset to
operate properly that's why better assign gpio reset to usb1 instead of
usb0.

Signed-off-by: Michal Simek <michal.simek@amd.com>
Link: https://lore.kernel.org/r/d117473da3bab39a82fe900cecd8ca78df9adeda.1683034376.git.michal.simek@amd.com

diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
index c74bc3f..685f8e4 100644 (file)
--- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
+++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
@@ -545,6 +545,7 @@
        pinctrl-0 = <&pinctrl_usb0_default>;
        phy-names = "usb3-phy";
        phys = <&psgtr 2 PHY_TYPE_USB3 0 0>;
+       /delete-property/ reset-gpios;
 };
 
 &dwc3_0 {
@@ -560,6 +561,7 @@
        pinctrl-0 = <&pinctrl_usb1_default>;
        phy-names = "usb3-phy";
        phys = <&psgtr 3 PHY_TYPE_USB3 1 0>;
+       reset-gpios = <&modepin_gpio 1 GPIO_ACTIVE_LOW>;
 };
 
 &dwc3_1 {