gpiolib: Read "gpio-line-names" from a firmware node

gpiolib: Read "gpio-line-names" from a firmware node

On STM32MP1, the GPIO banks are subnodes of pin-controller@50002000,
see arch/arm/boot/dts/stm32mp151.dtsi. The driver for
pin-controller@50002000 is in drivers/pinctrl/stm32/pinctrl-stm32.c
and iterates over all of its DT subnodes when registering each GPIO
bank gpiochip. Each gpiochip has:

  - gpio_chip.parent = dev,
    where dev is the device node of the pin controller
  - gpio_chip.of_node = np,
    which is the OF node of the GPIO bank

Therefore, dev_fwnode(chip->parent) != of_fwnode_handle(chip.of_node),
i.e. pin-controller@50002000 != pin-controller@50002000/gpio@5000*000.

The original code behaved correctly, as it extracted the "gpio-line-names"
from of_fwnode_handle(chip.of_node) = pin-controller@50002000/gpio@5000*000.

To achieve the same behaviour, read property from the firmware node.

Fixes: 7cba1a4d5e162 ("gpiolib: generalize devprop_gpiochip_set_names() for device properties")
Reported-by: Marek Vasut <marex@denx.de>
Reported-by: Roman Guskov <rguskov@dh-electronics.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Tested-by: Marek Vasut <marex@denx.de>
Reviewed-by: Marek Vasut <marex@denx.de>
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>