config FB_CT65550
bool "Chips 65550 display support"
- depends on (FB = y) && PPC32
+ depends on (FB = y) && PPC32 && PCI
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
help
This is the framebuffer device driver for a SHARP LQ043T1DG01 TFT LCD
+config FB_BFIN_T350MCQB
+ tristate "Varitronix COG-T350MCQB TFT LCD display (BF527 EZKIT)"
+ depends on FB && BLACKFIN
+ select BFIN_GPTIMERS
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ help
+ This is the framebuffer device driver for a Varitronix VL-PS-COG-T350MCQB-01 display TFT LCD
+ This display is a QVGA 320x240 24-bit RGB display interfaced by an 8-bit wide PPI
+ It uses PPI[0..7] PPI_FS1, PPI_FS2 and PPI_CLK.
+
+
config FB_STI
tristate "HP STI frame buffer device support"
depends on FB && PARISC
You will get a boot time penguin logo at no additional cost. Please
read <file:Documentation/fb/vesafb.txt>. If unsure, say Y.
+config FB_EFI
+ bool "EFI-based Framebuffer Support"
+ depends on (FB = y) && X86
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ help
+ This is the EFI frame buffer device driver. If the firmware on
+ your platform is UEFI2.0, select Y to add support for
+ Graphics Output Protocol for early console messages to appear.
+
config FB_IMAC
bool "Intel-based Macintosh Framebuffer Support"
depends on (FB = y) && X86 && EFI
config FB_ATMEL
tristate "AT91/AT32 LCD Controller support"
- depends on FB && (ARCH_AT91SAM9261 || ARCH_AT91SAM9263 || AVR32)
+ depends on FB && (ARCH_AT91SAM9261 || ARCH_AT91SAM9263 || ARCH_AT91SAM9RL || ARCH_AT91CAP9 || AVR32)
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
framebuffer. ML300 carries a 640*480 LCD display on the board,
ML403 uses a standard DB15 VGA connector.
+config FB_METRONOME
+ tristate "Metronome display controller support"
+ depends on FB && ARCH_PXA && MMU
+ select FB_SYS_FILLRECT
+ select FB_SYS_COPYAREA
+ select FB_SYS_IMAGEBLIT
+ select FB_SYS_FOPS
+ select FB_DEFERRED_IO
+ help
+ This enables support for the Metronome display controller. Tested
+ with an E-Ink 800x600 display and Gumstix Connex through an AMLCD
+ interface. Please read <file:Documentation/fb/metronomefb.txt>
+ for more information.
+
config FB_VIRTUAL
tristate "Virtual Frame Buffer support (ONLY FOR TESTING!)"
depends on FB