*/
#include <linux/err.h>
+#include <linux/gpio/consumer.h>
#include <linux/i2c.h>
#include <linux/interrupt.h>
#include <linux/kernel.h>
struct pca9450 {
struct device *dev;
struct regmap *regmap;
+ struct gpio_desc *sd_vsel_gpio;
enum pca9450_chip_type type;
unsigned int rcnt;
int irq;
BUCK1_RAMP_MASK, ramp_value << 6);
}
-static struct regulator_ops pca9450_dvs_buck_regulator_ops = {
+static const struct regulator_ops pca9450_dvs_buck_regulator_ops = {
.enable = regulator_enable_regmap,
.disable = regulator_disable_regmap,
.is_enabled = regulator_is_enabled_regmap,
.set_ramp_delay = pca9450_dvs_set_ramp_delay,
};
-static struct regulator_ops pca9450_buck_regulator_ops = {
+static const struct regulator_ops pca9450_buck_regulator_ops = {
.enable = regulator_enable_regmap,
.disable = regulator_disable_regmap,
.is_enabled = regulator_is_enabled_regmap,
.set_voltage_time_sel = regulator_set_voltage_time_sel,
};
-static struct regulator_ops pca9450_ldo_regulator_ops = {
+static const struct regulator_ops pca9450_ldo_regulator_ops = {
.enable = regulator_enable_regmap,
.disable = regulator_disable_regmap,
.is_enabled = regulator_is_enabled_regmap,
return ret;
}
+ /* Set reset behavior on assertion of WDOG_B signal */
+ ret = regmap_update_bits(pca9450->regmap, PCA9450_REG_RESET_CTRL,
+ WDOG_B_CFG_MASK, WDOG_B_CFG_COLD_LDO12);
+ if (ret) {
+ dev_err(&i2c->dev, "Failed to set WDOG_B reset behavior\n");
+ return ret;
+ }
+
+ /*
+ * The driver uses the LDO5CTRL_H register to control the LDO5 regulator.
+ * This is only valid if the SD_VSEL input of the PMIC is high. Let's
+ * check if the pin is available as GPIO and set it to high.
+ */
+ pca9450->sd_vsel_gpio = gpiod_get_optional(pca9450->dev, "sd-vsel", GPIOD_OUT_HIGH);
+
+ if (IS_ERR(pca9450->sd_vsel_gpio)) {
+ dev_err(&i2c->dev, "Failed to get SD_VSEL GPIO\n");
+ return ret;
+ }
+
dev_info(&i2c->dev, "%s probed.\n",
type == PCA9450_TYPE_PCA9450A ? "pca9450a" : "pca9450bc");