spi: pxa2xx: Get rid of unused enable_loopback member

[linux-2.6-microblaze.git] / Documentation / spi / pxa2xx.rst

diff --git a/Documentation/spi/pxa2xx.rst b/Documentation/spi/pxa2xx.rst
index dfc7673..6347580 100644 (file)
--- a/Documentation/spi/pxa2xx.rst
+++ b/Documentation/spi/pxa2xx.rst
@@ -101,7 +101,6 @@ device. All fields are optional.
        u8 rx_threshold;
        u8 dma_burst_size;
        u32 timeout;
-       u8 enable_loopback;
        int gpio_cs;
   };
 
@@ -128,11 +127,6 @@ dependent on the SPI bus speed ("spi_board_info.max_speed_hz") and the specific
 slave device.  Please note that the PXA2xx SSP 1 does not support trailing byte
 timeouts and must busy-wait any trailing bytes.
 
-The "pxa2xx_spi_chip.enable_loopback" field is used to place the SSP porting
-into internal loopback mode.  In this mode the SSP controller internally
-connects the SSPTX pin to the SSPRX pin.  This is useful for initial setup
-testing.
-
 NOTE: the SPI driver cannot control the chip select if SSPFRM is used, so the
 chipselect is dropped after each spi_transfer.  Most devices need chip select
 asserted around the complete message. Use SSPFRM as a GPIO (through a descriptor)