dt-bindings: usb: musb: Add support for MediaTek musb controller

[linux-2.6-microblaze.git] / Documentation / devicetree / bindings / usb / mediatek,musb.txt

diff --git a/Documentation/devicetree/bindings/usb/mediatek,musb.txt b/Documentation/devicetree/bindings/usb/mediatek,musb.txt
new file mode 100644 (file)
index 0000000..2b8a87c
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/mediatek,musb.txt
@@ -0,0 +1,57 @@
+MediaTek musb DRD/OTG controller
+-------------------------------------------
+
+Required properties:
+ - compatible      : should be one of:
+                     "mediatek,mt2701-musb"
+                     ...
+                     followed by "mediatek,mtk-musb"
+ - reg             : specifies physical base address and size of
+                     the registers
+ - interrupts      : interrupt used by musb controller
+ - interrupt-names : must be "mc"
+ - phys            : PHY specifier for the OTG phy
+ - dr_mode         : should be one of "host", "peripheral" or "otg",
+                     refer to usb/generic.txt
+ - clocks          : a list of phandle + clock-specifier pairs, one for
+                     each entry in clock-names
+ - clock-names     : must contain "main", "mcu", "univpll"
+                     for clocks of controller
+
+Optional properties:
+ - power-domains   : a phandle to USB power domain node to control USB's
+                     MTCMOS
+
+Required child nodes:
+ usb connector node as defined in bindings/connector/usb-connector.txt
+Optional properties:
+ - id-gpios        : input GPIO for USB ID pin.
+ - vbus-gpios      : input GPIO for USB VBUS pin.
+ - vbus-supply     : reference to the VBUS regulator, needed when supports
+                     dual-role mode
+ - usb-role-switch : use USB Role Switch to support dual-role switch, see
+                     usb/generic.txt.
+
+Example:
+
+usb2: usb@11200000 {
+       compatible = "mediatek,mt2701-musb",
+                    "mediatek,mtk-musb";
+       reg = <0 0x11200000 0 0x1000>;
+       interrupts = <GIC_SPI 32 IRQ_TYPE_LEVEL_LOW>;
+       interrupt-names = "mc";
+       phys = <&u2port2 PHY_TYPE_USB2>;
+       dr_mode = "otg";
+       clocks = <&pericfg CLK_PERI_USB0>,
+                <&pericfg CLK_PERI_USB0_MCU>,
+                <&pericfg CLK_PERI_USB_SLV>;
+       clock-names = "main","mcu","univpll";
+       power-domains = <&scpsys MT2701_POWER_DOMAIN_IFR_MSC>;
+       usb-role-switch;
+       connector{
+               compatible = "gpio-usb-b-connector", "usb-b-connector";
+               type = "micro";
+               id-gpios = <&pio 44 GPIO_ACTIVE_HIGH>;
+               vbus-supply = <&usb_vbus>;
+       };
+};