by writing INTERFACE to /sys/bus/usb/drivers_probe
This allows to avoid side-effects with drivers
that need multiple interfaces.
+
A deauthorized interface cannot be probed or claimed.
What: /sys/bus/usb/devices/usbX/interface_authorized_default
table at compile time. The format for the device ID is:
idVendor idProduct bInterfaceClass RefIdVendor RefIdProduct
The vendor ID and device ID fields are required, the
- rest is optional. The Ref* tuple can be used to tell the
+ rest is optional. The `Ref*` tuple can be used to tell the
driver to use the same driver_data for the new device as
it is used for the reference device.
Upon successfully adding an ID, the driver will probe
- for the device and attempt to bind to it. For example:
- # echo "8086 10f5" > /sys/bus/usb/drivers/foo/new_id
+ for the device and attempt to bind to it. For example::
+
+ # echo "8086 10f5" > /sys/bus/usb/drivers/foo/new_id
Here add a new device (0458:7045) using driver_data from
- an already supported device (0458:704c):
- # echo "0458 7045 0 0458 704c" > /sys/bus/usb/drivers/foo/new_id
+ an already supported device (0458:704c)::
+
+ # echo "0458 7045 0 0458 704c" > /sys/bus/usb/drivers/foo/new_id
Reading from this file will list all dynamically added
device IDs in the same format, with one entry per
- line. For example:
- # cat /sys/bus/usb/drivers/foo/new_id
- 8086 10f5
- dead beef 06
- f00d cafe
+ line. For example::
+
+ # cat /sys/bus/usb/drivers/foo/new_id
+ 8086 10f5
+ dead beef 06
+ f00d cafe
The list will be truncated at PAGE_SIZE bytes due to
sysfs restrictions.
advance, and behaves well according to the specification.
This attribute is a bit-field that controls the behavior of
a specific port:
+
- Bit 0 of this field selects the "old" enumeration scheme,
as it is considerably faster (it only causes one USB reset
instead of 2).
+
The old enumeration scheme can also be selected globally
using /sys/module/usbcore/parameters/old_scheme_first, but
it is often not desirable as the new scheme was introduced to
poll() for monitoring changes to this value in user space.
Any time this value changes the corresponding hub device will send a
- udev event with the following attributes:
+ udev event with the following attributes::
- OVER_CURRENT_PORT=/sys/bus/usb/devices/.../(hub interface)/portX
- OVER_CURRENT_COUNT=[current value of this sysfs attribute]
+ OVER_CURRENT_PORT=/sys/bus/usb/devices/.../(hub interface)/portX
+ OVER_CURRENT_COUNT=[current value of this sysfs attribute]
What: /sys/bus/usb/devices/.../(hub interface)/portX/usb3_lpm_permit
Date: November 2015