1 /* SPDX-License-Identifier: GPL-2.0 */
5 #include <linux/device.h>
8 #include <linux/jiffies.h>
9 #include <linux/mmc/card.h>
10 #include <linux/platform_device.h>
11 #include <linux/pm_runtime.h>
13 #define tmio_ioread8(addr) readb(addr)
14 #define tmio_ioread16(addr) readw(addr)
15 #define tmio_ioread16_rep(r, b, l) readsw(r, b, l)
16 #define tmio_ioread32(addr) \
17 (((u32)readw((addr))) | (((u32)readw((addr) + 2)) << 16))
19 #define tmio_iowrite8(val, addr) writeb((val), (addr))
20 #define tmio_iowrite16(val, addr) writew((val), (addr))
21 #define tmio_iowrite16_rep(r, b, l) writesw(r, b, l)
22 #define tmio_iowrite32(val, addr) \
24 writew((val), (addr)); \
25 writew((val) >> 16, (addr) + 2); \
28 #define sd_config_write8(base, shift, reg, val) \
29 tmio_iowrite8((val), (base) + ((reg) << (shift)))
30 #define sd_config_write16(base, shift, reg, val) \
31 tmio_iowrite16((val), (base) + ((reg) << (shift)))
32 #define sd_config_write32(base, shift, reg, val) \
34 tmio_iowrite16((val), (base) + ((reg) << (shift))); \
35 tmio_iowrite16((val) >> 16, (base) + ((reg + 2) << (shift))); \
38 /* tmio MMC platform flags */
40 * Some controllers can support a 2-byte block size when the bus width
41 * is configured in 4-bit mode.
43 #define TMIO_MMC_BLKSZ_2BYTES BIT(1)
45 * Some controllers can support SDIO IRQ signalling.
47 #define TMIO_MMC_SDIO_IRQ BIT(2)
49 /* Some features are only available or tested on R-Car Gen2 or later */
50 #define TMIO_MMC_MIN_RCAR2 BIT(3)
53 * Some controllers require waiting for the SD bus to become
54 * idle before writing to some registers.
56 #define TMIO_MMC_HAS_IDLE_WAIT BIT(4)
58 /* BIT(5) is unused */
61 * Some controllers have CMD12 automatically
62 * issue/non-issue register
64 #define TMIO_MMC_HAVE_CMD12_CTRL BIT(7)
66 /* Controller has some SDIO status bits which must be 1 */
67 #define TMIO_MMC_SDIO_STATUS_SETBITS BIT(8)
70 * Some controllers have a 32-bit wide data port register
72 #define TMIO_MMC_32BIT_DATA_PORT BIT(9)
75 * Some controllers allows to set SDx actual clock
77 #define TMIO_MMC_CLK_ACTUAL BIT(10)
79 /* Some controllers have a CBSY bit */
80 #define TMIO_MMC_HAVE_CBSY BIT(11)
82 /* Some controllers that support HS400 use 4 taps while others use 8. */
83 #define TMIO_MMC_HAVE_4TAP_HS400 BIT(13)
85 int tmio_core_mmc_enable(void __iomem *cnf, int shift, unsigned long base);
86 int tmio_core_mmc_resume(void __iomem *cnf, int shift, unsigned long base);
87 void tmio_core_mmc_pwr(void __iomem *cnf, int shift, int state);
88 void tmio_core_mmc_clk_div(void __iomem *cnf, int shift, int state);
93 * data for the MMC controller
95 struct tmio_mmc_data {
99 unsigned long capabilities;
100 unsigned long capabilities2;
102 u32 ocr_mask; /* available voltages */
104 dma_addr_t dma_rx_offset;
105 unsigned int max_blk_count;
106 unsigned short max_segs;
107 void (*set_pwr)(struct platform_device *host, int state);
108 void (*set_clk_div)(struct platform_device *host, int state);
112 * data for the NAND controller
114 struct tmio_nand_data {
115 struct nand_bbt_descr *badblock_pattern;
116 struct mtd_partition *partition;
117 unsigned int num_partitions;
118 const char *const *part_parsers;
121 #define FBIO_TMIO_ACC_WRITE 0x7C639300
122 #define FBIO_TMIO_ACC_SYNC 0x7C639301
124 struct tmio_fb_data {
125 int (*lcd_set_power)(struct platform_device *fb_dev,
127 int (*lcd_mode)(struct platform_device *fb_dev,
128 const struct fb_videomode *mode);
130 struct fb_videomode *modes;
132 /* in mm: size of screen */