1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * at25.c -- support most SPI EEPROMs, such as Atmel AT25 models
5 * Copyright (C) 2006 David Brownell
8 #include <linux/kernel.h>
9 #include <linux/module.h>
10 #include <linux/slab.h>
11 #include <linux/delay.h>
12 #include <linux/device.h>
13 #include <linux/sched.h>
15 #include <linux/nvmem-provider.h>
16 #include <linux/spi/spi.h>
17 #include <linux/spi/eeprom.h>
18 #include <linux/property.h>
21 * NOTE: this is an *EEPROM* driver. The vagaries of product naming
22 * mean that some AT25 products are EEPROMs, and others are FLASH.
23 * Handle FLASH chips with the drivers/mtd/devices/m25p80.c driver,
26 * EEPROMs that can be used with this driver include, for example:
31 struct spi_device *spi;
33 struct spi_eeprom chip;
35 struct nvmem_config nvmem_config;
36 struct nvmem_device *nvmem;
39 #define AT25_WREN 0x06 /* latch the write enable */
40 #define AT25_WRDI 0x04 /* reset the write enable */
41 #define AT25_RDSR 0x05 /* read status register */
42 #define AT25_WRSR 0x01 /* write status register */
43 #define AT25_READ 0x03 /* read byte(s) */
44 #define AT25_WRITE 0x02 /* write byte(s)/sector */
46 #define AT25_SR_nRDY 0x01 /* nRDY = write-in-progress */
47 #define AT25_SR_WEN 0x02 /* write enable (latched) */
48 #define AT25_SR_BP0 0x04 /* BP for software writeprotect */
49 #define AT25_SR_BP1 0x08
50 #define AT25_SR_WPEN 0x80 /* writeprotect enable */
52 #define AT25_INSTR_BIT3 0x08 /* Additional address bit in instr */
54 #define EE_MAXADDRLEN 3 /* 24 bit addresses, up to 2 MBytes */
56 /* Specs often allow 5 msec for a page write, sometimes 20 msec;
57 * it's important to recover from write timeouts.
61 /*-------------------------------------------------------------------------*/
63 #define io_limit PAGE_SIZE /* bytes */
65 static int at25_ee_read(void *priv, unsigned int offset,
66 void *val, size_t count)
68 struct at25_data *at25 = priv;
70 u8 command[EE_MAXADDRLEN + 1];
73 struct spi_transfer t[2];
77 if (unlikely(offset >= at25->chip.byte_len))
79 if ((offset + count) > at25->chip.byte_len)
80 count = at25->chip.byte_len - offset;
87 if (at25->chip.flags & EE_INSTR_BIT3_IS_ADDR)
88 if (offset >= (1U << (at25->addrlen * 8)))
89 instr |= AT25_INSTR_BIT3;
92 /* 8/16/24-bit address is written MSB first */
93 switch (at25->addrlen) {
101 case 0: /* can't happen: for better codegen */
105 spi_message_init(&m);
106 memset(t, 0, sizeof(t));
108 t[0].tx_buf = command;
109 t[0].len = at25->addrlen + 1;
110 spi_message_add_tail(&t[0], &m);
114 spi_message_add_tail(&t[1], &m);
116 mutex_lock(&at25->lock);
118 /* Read it all at once.
120 * REVISIT that's potentially a problem with large chips, if
121 * other devices on the bus need to be accessed regularly or
122 * this chip is clocked very slowly
124 status = spi_sync(at25->spi, &m);
125 dev_dbg(&at25->spi->dev, "read %zu bytes at %d --> %zd\n",
126 count, offset, status);
128 mutex_unlock(&at25->lock);
132 static int at25_ee_write(void *priv, unsigned int off, void *val, size_t count)
134 struct at25_data *at25 = priv;
135 const char *buf = val;
140 if (unlikely(off >= at25->chip.byte_len))
142 if ((off + count) > at25->chip.byte_len)
143 count = at25->chip.byte_len - off;
144 if (unlikely(!count))
147 /* Temp buffer starts with command and address */
148 buf_size = at25->chip.page_size;
149 if (buf_size > io_limit)
151 bounce = kmalloc(buf_size + at25->addrlen + 1, GFP_KERNEL);
155 /* For write, rollover is within the page ... so we write at
156 * most one page, then manually roll over to the next page.
158 mutex_lock(&at25->lock);
160 unsigned long timeout, retries;
162 unsigned offset = (unsigned) off;
168 status = spi_write(at25->spi, cp, 1);
170 dev_dbg(&at25->spi->dev, "WREN --> %d\n", status);
175 if (at25->chip.flags & EE_INSTR_BIT3_IS_ADDR)
176 if (offset >= (1U << (at25->addrlen * 8)))
177 instr |= AT25_INSTR_BIT3;
180 /* 8/16/24-bit address is written MSB first */
181 switch (at25->addrlen) {
182 default: /* case 3 */
183 *cp++ = offset >> 16;
189 case 0: /* can't happen: for better codegen */
193 /* Write as much of a page as we can */
194 segment = buf_size - (offset % buf_size);
197 memcpy(cp, buf, segment);
198 status = spi_write(at25->spi, bounce,
199 segment + at25->addrlen + 1);
200 dev_dbg(&at25->spi->dev, "write %u bytes at %u --> %d\n",
201 segment, offset, status);
205 /* REVISIT this should detect (or prevent) failed writes
206 * to readonly sections of the EEPROM...
209 /* Wait for non-busy status */
210 timeout = jiffies + msecs_to_jiffies(EE_TIMEOUT);
214 sr = spi_w8r8(at25->spi, AT25_RDSR);
215 if (sr < 0 || (sr & AT25_SR_nRDY)) {
216 dev_dbg(&at25->spi->dev,
217 "rdsr --> %d (%02x)\n", sr, sr);
218 /* at HZ=100, this is sloooow */
222 if (!(sr & AT25_SR_nRDY))
224 } while (retries++ < 3 || time_before_eq(jiffies, timeout));
226 if ((sr < 0) || (sr & AT25_SR_nRDY)) {
227 dev_err(&at25->spi->dev,
228 "write %u bytes offset %u, timeout after %u msecs\n",
230 jiffies_to_msecs(jiffies -
231 (timeout - EE_TIMEOUT)));
242 mutex_unlock(&at25->lock);
248 /*-------------------------------------------------------------------------*/
250 static int at25_fw_to_chip(struct device *dev, struct spi_eeprom *chip)
254 memset(chip, 0, sizeof(*chip));
255 strncpy(chip->name, "at25", sizeof(chip->name));
257 if (device_property_read_u32(dev, "size", &val) == 0 ||
258 device_property_read_u32(dev, "at25,byte-len", &val) == 0) {
259 chip->byte_len = val;
261 dev_err(dev, "Error: missing \"size\" property\n");
265 if (device_property_read_u32(dev, "pagesize", &val) == 0 ||
266 device_property_read_u32(dev, "at25,page-size", &val) == 0) {
267 chip->page_size = val;
269 dev_err(dev, "Error: missing \"pagesize\" property\n");
273 if (device_property_read_u32(dev, "at25,addr-mode", &val) == 0) {
274 chip->flags = (u16)val;
276 if (device_property_read_u32(dev, "address-width", &val)) {
278 "Error: missing \"address-width\" property\n");
283 chip->flags |= EE_INSTR_BIT3_IS_ADDR;
286 chip->flags |= EE_ADDR1;
289 chip->flags |= EE_ADDR2;
292 chip->flags |= EE_ADDR3;
296 "Error: bad \"address-width\" property: %u\n",
300 if (device_property_present(dev, "read-only"))
301 chip->flags |= EE_READONLY;
306 static int at25_probe(struct spi_device *spi)
308 struct at25_data *at25 = NULL;
309 struct spi_eeprom chip;
314 /* Chip description */
315 if (!spi->dev.platform_data) {
316 err = at25_fw_to_chip(&spi->dev, &chip);
320 chip = *(struct spi_eeprom *)spi->dev.platform_data;
322 /* For now we only support 8/16/24 bit addressing */
323 if (chip.flags & EE_ADDR1)
325 else if (chip.flags & EE_ADDR2)
327 else if (chip.flags & EE_ADDR3)
330 dev_dbg(&spi->dev, "unsupported address type\n");
334 /* Ping the chip ... the status register is pretty portable,
335 * unlike probing manufacturer IDs. We do expect that system
336 * firmware didn't write it in the past few milliseconds!
338 sr = spi_w8r8(spi, AT25_RDSR);
339 if (sr < 0 || sr & AT25_SR_nRDY) {
340 dev_dbg(&spi->dev, "rdsr --> %d (%02x)\n", sr, sr);
344 at25 = devm_kzalloc(&spi->dev, sizeof(struct at25_data), GFP_KERNEL);
348 mutex_init(&at25->lock);
351 spi_set_drvdata(spi, at25);
352 at25->addrlen = addrlen;
354 at25->nvmem_config.type = NVMEM_TYPE_EEPROM;
355 at25->nvmem_config.name = dev_name(&spi->dev);
356 at25->nvmem_config.dev = &spi->dev;
357 at25->nvmem_config.read_only = chip.flags & EE_READONLY;
358 at25->nvmem_config.root_only = true;
359 at25->nvmem_config.owner = THIS_MODULE;
360 at25->nvmem_config.compat = true;
361 at25->nvmem_config.base_dev = &spi->dev;
362 at25->nvmem_config.reg_read = at25_ee_read;
363 at25->nvmem_config.reg_write = at25_ee_write;
364 at25->nvmem_config.priv = at25;
365 at25->nvmem_config.stride = 1;
366 at25->nvmem_config.word_size = 1;
367 at25->nvmem_config.size = chip.byte_len;
369 at25->nvmem = devm_nvmem_register(&spi->dev, &at25->nvmem_config);
370 if (IS_ERR(at25->nvmem))
371 return PTR_ERR(at25->nvmem);
373 dev_info(&spi->dev, "%d %s %s eeprom%s, pagesize %u\n",
374 (chip.byte_len < 1024) ? chip.byte_len : (chip.byte_len / 1024),
375 (chip.byte_len < 1024) ? "Byte" : "KByte",
377 (chip.flags & EE_READONLY) ? " (readonly)" : "",
378 at25->chip.page_size);
382 /*-------------------------------------------------------------------------*/
384 static const struct of_device_id at25_of_match[] = {
385 { .compatible = "atmel,at25", },
388 MODULE_DEVICE_TABLE(of, at25_of_match);
390 static struct spi_driver at25_driver = {
393 .of_match_table = at25_of_match,
398 module_spi_driver(at25_driver);
400 MODULE_DESCRIPTION("Driver for most SPI EEPROMs");
401 MODULE_AUTHOR("David Brownell");
402 MODULE_LICENSE("GPL");
403 MODULE_ALIAS("spi:at25");