1 * Freescale Fast Ethernet Controller (FEC)
4 - compatible : Should be "fsl,<soc>-fec"
5 - reg : Address and length of the register set for the device
6 - interrupts : Should contain fec interrupt
7 - phy-mode : See ethernet.txt file in the same directory
10 - phy-reset-gpios : Should specify the gpio for phy reset
11 - phy-reset-duration : Reset duration in milliseconds. Should present
12 only if property "phy-reset-gpios" is available. Missing the property
13 will have the duration be 1 millisecond. Numbers greater than 1000 are
14 invalid and 1 millisecond will be used instead.
15 - phy-reset-active-high : If present then the reset sequence using the GPIO
16 specified in the "phy-reset-gpios" property is reversed (H=reset state,
18 - phy-reset-post-delay : Post reset delay in milliseconds. If present then
19 a delay of phy-reset-post-delay milliseconds will be observed after the
20 phy-reset-gpios has been toggled. Can be omitted thus no delay is
21 observed. Delay is in range of 1ms to 1000ms. Other delays are invalid.
22 - phy-supply : regulator that powers the Ethernet PHY.
23 - phy-handle : phandle to the PHY device connected to this device.
24 - fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
25 Use instead of phy-handle.
26 - fsl,num-tx-queues : The property is valid for enet-avb IP, which supports
27 hw multi queues. Should specify the tx queue number, otherwise set tx queue
29 - fsl,num-rx-queues : The property is valid for enet-avb IP, which supports
30 hw multi queues. Should specify the rx queue number, otherwise set rx queue
32 - fsl,magic-packet : If present, indicates that the hardware supports waking
34 - fsl,err006687-workaround-present: If present indicates that the system has
35 the hardware workaround for ERR006687 applied and does not need a software
39 - mdio : specifies the mdio bus in the FEC, used as a container for phy nodes
40 according to phy.txt in the same directory
45 compatible = "fsl,imx51-fec", "fsl,imx27-fec";
46 reg = <0x83fec000 0x4000>;
49 phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
50 local-mac-address = [00 04 9F 01 1B B9];
51 phy-supply = <®_fec_supply>;
54 Example with phy specified:
57 compatible = "fsl,imx51-fec", "fsl,imx27-fec";
58 reg = <0x83fec000 0x4000>;
61 phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
62 local-mac-address = [00 04 9F 01 1B B9];
63 phy-supply = <®_fec_supply>;
64 phy-handle = <ðphy>;
66 ethphy: ethernet-phy@6 {
67 compatible = "ethernet-phy-ieee802.3-c22";