1 Generic Bluetooth controller over USB (btusb driver)
2 ---------------------------------------------------
6 - compatible : should comply with the format "usbVID,PID" specified in
7 Documentation/devicetree/bindings/usb/usb-device.txt
8 At the time of writing, the only OF supported devices
9 (more may be added later) are:
11 "usb1286,204e" (Marvell 8997)
13 Also, vendors that use btusb may have device additional properties, e.g:
14 Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt
18 - interrupt-parent: phandle of the parent interrupt controller
19 - interrupt-names: (see below)
20 - interrupts : The interrupt specified by the name "wakeup" is the interrupt
21 that shall be used for out-of-band wake-on-bt. Driver will
22 request this interrupt for wakeup. During system suspend, the
23 irq will be enabled so that the bluetooth chip can wakeup host
24 platform out of band. During system resume, the irq will be
25 disabled to make sure unnecessary interrupt is not received.
29 Following example uses irq pin number 3 of gpio0 for out of band wake-on-bt:
36 compatible = "usb1286,204e";
38 interrupt-parent = <&gpio0>;
39 interrupt-name = "wakeup";
40 interrupts = <3 IRQ_TYPE_LEVEL_LOW>;